Chapter 3: Configuration and Commissioning
ModuLaser Modular Aspirating Smoke Detector Installation Manual 37
To exit a restricted access level:
1. Press F2 (Logout) from the Main menu.
An automatic timeout period can also be configured to exit a restricted access
level if no keys are pressed. See “Changing screen properties” on page 45.
To change an access code:
1. Login to your access level, and then select General Settings from the Main
menu.
2. Select Access Codes, and then select the access code level that you want to
change.
Level 2 users can only change level 2 access codes. Level 3 users can
change access codes for levels 2 and 3. Level 4 users can change access
codes for levels 2, 3, and 4.
3. Enter the new access code twice.
4. Press F1 (Save) to save your changes and exit to the previous screen.
5. If you have no other configuration changes to make, then press F1 (Apply)
from the Main menu or the submenu to apply the changes to the system.
Configuration overview
Note: Configuration options provided in this manual are for the ModuLaser
system only and may differ from legacy ASD units.
Configuration methods
The detection system can be configured using the display module controls or via
a PC. For best results we recommend that the detection system is configured
using the Remote software application.
Scope of configuration
If configured using a display module, the scope of configuration is defined by the
module used, as shown in the table below.
Scope
Configures any device connected to a SenseNET network
Configures any device in the associated cluster.
To Next Page
Loading...
