This product has been manufactured under a quality management system certified to ISO 9001:2015
Additional Legislation and Compliance Information
EU EMC Directive: Class A/B equipment
Caution: This equipment is not intended for use in residential environments and may not provide adequate protection to
radio reception in such environments.
EU RoHS Directive: Material Exemption Information
This product is compliant with the following Annex III Exemptions:
• 6(b) Lead as an alloying element in aluminium containing up to 0.4% by weight
• 6(c) Copper alloy containing up to 4% lead by weight
• 8(b) Cadmium and its compounds in electrical contacts
EU REACH Regulation Compliance
This product is a complex article which is not designed for intentional substance release. To the best of our knowledge
the materials used comply with the requirements of REACH. The product manual provides information and instruction to
ensure the safe storage, use, maintenance and disposal of the product including any substance based requirements.
Article 33.1 Declaration
This product does not knowingly or intentionally contain Candidate List Substances of Very High Concern above 0.1%ww
by article as clarified under the 2015 European Court of Justice ruling in case C-106/14.
• Cadmium (Cd) added to the Candidate List June 2013
As indicated by the applied RoHS exemption above, this substance is present in electronic componentry
• Lead (Pb) added to the Candidate List June 2018
As indicated by the applied RoHS exemption(s) above this substance is present in certain aluminium/brass components.
ADDITIONAL INFORMATION
The products listed are also in scope for and comply with the requirements of the following:
Directive on waste electrical and electronic equipment (WEEE)
Product is certified to
CSA-C22.2 No.61010-1-12
Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 1: General requirements
Product conforms to
UL61010-1 3
rd
Safety requirements for electrical equipment for measurement, control and
laboratory use – Part 1: General requirements