M561-00-880 Issue C
Page 54 © Edwards Limited 2012. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
7.3 Ordering accessories
* AAM includes a PAM
If you wish to restrain your system using seismic brackets you will need to order the correct brackets for your
particular system, refer to Table 23.
Table 22 - Accessories
Description Item Number
Seismic bracket kits (refer to Tabl e 23): A50767000 or A50768000
Retrofit kit to enable installation of iXH in place of iH1000:
For iXH1210 and iXH1210H A50769000
For iXH1220H A50770000
Exhaust extraction cover kit:
For NW40 exhaust A50780000
For NW50 exhaust A50791000
Exhaust Check Valve Kits:
NW40 (refer to Table 24) A50782000 or A50787000
NW50, PTFE Disc type (for iXL systems) A50790000
Nitrogen flow switches:
Suitable for 0 - 60 slm A50784000
Suitable for 0 - 204 slm A50785000
Utilities kit (contains mating half quick connectors for cooling water and
electrical connector mating parts):
Kit suitable for 380 - 460V systems using the Harting Han® 100A axial screw
module mains connector
A50788000
Kit suitable for 200 - 230V systems using the Harting Han® 100A axial screw
module mains connector
A50789000
Kit suitable for all systems using the Harting Han® K4/4 mains connector A50795000
Photohelic switch and gauge kit A50803000
Disconnect box (used with photohelic):
200 – 230 V 60 A max (suitable for systems with the Harting Han® K4/4 mains
connector)
A50802000
200 – 230 V 100 A max (suitable for systems with the Harting Han® 100A axial
screw module mains connector)
A50804000
pXH drip tray (used to fully satisfy SEMI S2 requirements) Contact Edwards
Accessory modules:
Active Accessory Module (AAM)* D37480500
Passive Accessory Module (PAM)* D37480550
PDT D37280700
To Next Page
Loading...
Need help?
General
