EFKA FP220A5911
49
11 Functions with or without Control Panel
11.1 Softstart
Function with or without control panel Parameter
Softstart On/Off (SSt) 134
Functions:
! after power on
!
at the beginning of a new seam
! speed pedal controlled and limited to (n6)
! lower speed of a parallel function prevailing (e. g. start backtack, stitch counting)
!
stitch counting synchronized to position 1
! suspension with pedal in position 0 (neutral)
! interruption by full heelback (position -2)
When using the V820 control panel, direct access by means of the function key (9 key) is possible!
Function with control panel Parameter
Softstart On/Off (-F-) 008 = 1
11.1.1 Softstart Speed
Function with or without control panel Parameter
Softstart speed (n6) 115
When programming 3-digit or 4-digit parameter values on the control, the 2-digit or 3-digit values displayed must be
multiplied by 10.
11.1.2 Softstart Stitches
Function with or without control panel Parameter
Number of softstart stitches (SSc) 100
The letter symbols in parentheses ( ) are visible only if the V820 control panel is connected!
11.2 Sewing Foot Lifting
Function without control panel Control
Automatic in the seam lefthand LED above key On S4 key
Automatic after thread trimming righthand LED above key On S4 key
Function with control panel V810 V820
Automatic in the seam lefthand arrow above key On 3 key 6 key
Automatic after thread trimming righthand arrow above key On 3 key 6 key
If parameter 290 = 16, with slide-in strip “7“ lefthand arrow above key On 9 key
To Next Page
Loading...