EFKA FP220A5911
61
11.14.3 Setting the Speed Limitation Depending on High Lift with the V810 Control
Panel
! Call parameter 188.
!
Press the E key. "
! Press theF2 key. Actual display. "
! Press the F2 key. Previous values are displayed. "
! Press the F2 key. "
!
Set new value (level) with potentiometer on the machine. "
! Press the F2 key. "
!
Press the E key. New value 08 (upper break point) "
is entered.
!
Press theF2 key. "
!
Set new value (level) with potentiometer on the machine. "
! Press the F2 key. "
!
Press the E key. New value 17 (lower break point) "
is entered.
! Press the P key once. Display of the actual parameter "
number.
or
!
Press the P key twice. Exit programming. "
These values are saved when you start sewing. They remain in effect even after turning the machine off!
Note
If you set a value on the potentiometer, which is between the actual break points, both values will be overwritten when
pressing the E key. Only after that is it possible to program new lower and/or upper break point values.
E
hP [ ° ]
F2
1 1. 3 2 0 0
F2
0 5 1 9
F2
1 1. 3 2 0 0
0 8. 3 2 0 0
F2
0 5 1 9
E
0 8 0 8
F2
0 8. 3 2 0 0
1 7. 3 2 0 0
F2
0 8 0 8
E
0 8 1 7
P
F - 1 8 8
P
F P 2 2 0 A
P
To Next Page
Loading...