Efka dc 1500 - 11.11 Unlocking the Chain (Mode 4;5;6;7;16); 11.13.3 High Lift Walking Stitches; 11.14 Speed Depending on High Lift; 11.14.1 Operating Mode of Speed Limitation Depending on High Lift

EFKA FP220A5911
60
Graduation of the examples below is as follows:
Speed
3500 XXXXXupper speed break point
3200 X
3110 X
3020 X
2930 X
2840 X
2740 ----------------------------------------------------------- X
2650 X
2560 X
2470 X
2380 X
2280 X
2190 X
2100 X
2000 lower speed break point X X X
01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 Levels
Display example of parameter 188 on the V820 control panel: "
Signification: XX
"
Display of the level up to which the maximum speed is effective
(upper break point).
YY " Display of the level from which the maximum speed is effective
(lower break point).
AB " Diplay of the level set on the potentiometer.
ZZZZ " Speed resulting from the set high lift level.
EEEE
"
Outside of the speed range.
11.14.2 Setting the Speed Limitation Depending on High Lift with the V820 Control
Panel
! Determine maximum speed (n2) by means of parameter 111.
! Determine minimum speed (n10) by means of parameter 117.
! Set parameter 126 to “3“.
! Call parameter 188.
! Press the E key. "
! Press the F2 key. "
! Set high lift for walking foot (potentiometer on the machine) to the level up to which full speed is to be maintained
(upper break point).
! New value of AB is taken over to XX. "
! Set high lift for walking foot (potentiometer on the machine) to the level from which minimum speed is to be effective
(lower break point).
! New value of AB is taken over to YY. "
! Press P key once " Actual parameter is displayed. / Press P key twice " Exit programming.
ZZZZ XX AB YY
E
F–188 hP [ ° ]
F2
ZZZZ XX AB YY
E
ZZZZ XX AB YY
E
ZZZZ XX AB YY