43
Transfer of the packet data to the HDBaseT serial port
The packet data that is not for the PX-30E will be transferred to the RS-232C port of the HDBaseT
receiver via HDBaseT. With this function, you can control a device connected to the PX-30E with
the HDBaseT cable through serial communication remotely.
You can also control the PX-30E from the HDBaseT receiver side through serial communication.
・For the information of RS-232C command, etc., contact the dealer from whom you have
purchased the PX-10E/30E or our nearest branch office or sales office listed on the supplied
Peripheral equipment
(e.g. projector)
・If CTS and RTS are selected in the RS232C settings menu of the external device connected to a
Euroblock compatible unit, make a short circuit between the CTS port and RTS port of the
To Next Page
Loading...
