50 BA-en-3041-2008_PC
• Setting the CANopen® node address
Setting the CANopen® node address is a two-step process: first you set
the tens for the address 0 –12, then the units of the address 0–9. These
settings define the address as follows:
Node address = (tens position * 10) + units position
The 14th LED of the bar shows that the address is being set. The LEDs on
the left indicate the current selection.
Fig. 31:
Image detail:
"Setting the
CANopen® node
address" with illu-
minated 14th LED
Z-116036dy_8
Fig. 32:
Image detail:
"Setting the
CANopen® node
address" with illu-
minated 14th LED
for
"System Master"
Z-116036dy_18
To Next Page
Loading...
