BA-en-3041-2008_PC 51
• Setting the CANopen® transmission rate
The 15th LED of the bar lights up for the setting of the transmission rate.
The left part of the bar shows the currently selected setting. The setting
can be changed with the + and - buttons. Confirm your selection with the
OK button. The Setup menu automatically goes to the mode for conclu-
ding the setup. The current selection is shown by the individual LEDs:
LED 1: 1000 kBit/s
LED 2: 800 kBit/s
LED 3: 500 kBit/s
LED 4: 250 kBit/s
LED 5: 125 kBit/s
LED 6: 50 kBit/s
LED 7: 20 kBit/s
LED 8: 10 kBit/s
Fig. 33:
Image detail:
"Setting
CANopen® trans-
mission rate"
with illuminated
15th LED
Z-116036dy_9
Fig. 34:
Image detail:
"Setting
CANopen® trans-
mission rate"
with illuminated
15th LED for
"System Master"
Z-116036dy_19
To Next Page
Loading...
