ELTEX SMG-4 - Page 151

SMG digital gateway 151
incoming long-distance calls instead of
the "Subscriber". At that, the
transmitted number should be as
follows: ABCabxxxxx, or 2abxxxxx, or
10 <international number>.
International umber—used in LD and
CLR lines for outgoing international
calls. At that, the transmitted number
should be as follows: <international
number> (without the international
network exit prefix—"10").
config
Return to the Configuration menu
dial mode
<MODE>
nochange/enblock/
overlap
Define the prefix dialling mode:
- enblock—the callee number is sent as
a block;
- overlap—the callee number is sent
with an overlap (by a single digit);
- nochange—the callee number is sent
in the form it has been received from
the incoming channel.
direction
<PFX_DIRECTION>
local/
Emergency/
zone/
vedomst/
toll/
international
Define the type of access to the trunk
group:
local—local;
emergency—emergency call;
zone—zone access;
vedomst—to a private network;
toll—to a long-distance network;
international—to an international
network.
duration
<PFX_DURATION>
0-255
Set the number dialling duration
timer, in seconds
exit
Return from this configuration
submenu to an upper level
getCID
<ON_OFF>
on/off
Enable/disable Caller ID request for
prefix routing
history
Show the history of entered
commands
mask edit
Enter the prefix mask editing mode
mask show
Show prefix masks
name
<s_name>
String, 31 characters
max. (allowed
characters: letters,
numbers, and "_")
Set prefix name/designation
needCID
<ON_OFF>
on/off
Enable/disable CallerID mandatory
information request
numplan
<PLAN_IDX>
0-15
Define the numbering schedule the
prefix belongs to
notdial ST
<USE_ST>
yes/no
Disable/enable transmission of the end
dial marker (ST in SS or "sending
complete" in PRI)
priority
<PRIORITY>
0-100
Set prefix priority:
0—the highest priority;
100—the lowest priority.
quit
Terminate this CLI session