15
1
2
CH
1
2
E+
E-
FP
M
12V
CP
Functions of the video door entry unit
Activating Auxiliary Functions.
The activation command of any auxiliary functions can be used to activate services or external devices such
as, for instance, courtesy lights, automations, etc.
To activate the control, either with a call in progress or without a call or during self-start, tap the softkey A,
select the desired function with B and C and tap D; the control is active when operating with the MONITOR ON.
As regards the supporting relays, it is possible to use the external digital relay art. 69RH with applicable load
3 A or 69PH with applicable load 6 A - AC1.
You can use the AUX SERVICE 1/2 commands with the support of an external digital relay art. 69RH or 69PH.
The activation time of the AUX SERVICES 1..16 can be set directly from the relay (for full details, please see
the documentation for art. 69RH or 69PH).
Doorbell calls.
This application enables, with a normal N.O. button outside and connected directly to the video door entry unit,
accomplishing the function performed by the traditional doorbell.
The N.O. button must be connected to terminals "FP" and "M" of the video touchscreen and, on pressing this
button, the video door entry unit will beep without however turning on the display; the ringtone is set from the
menu and corresponds to adjusting the ringtone from the landing.
Example installation
Figure 12 - Doorbell calls
CP - N.O. call button
VV - Video door entry unit 5721
To Next Page
Loading...
Need help?
General
