EMC CLARiiON - About EMC Navisphere Software; Navisphere Initialization Utility

1-2
EMC CLARiiON Server Support Products for Windows Installation Guide
About the CLARiiON Server Applications
About EMC Navisphere software
The following EMC
®
server-based software is available on the server
support CD that shipped with your storage system or your upgrade
kit (for AX-Series systems upgrading to Navisphere Manager):
◆ Navisphere
®
Storage System Initialization Utility
◆ Navisphere Host Agent
◆ Navisphere Server Utility
◆ Admhost Utility
◆ Admsnap Utility
◆ CLARiiON
®
VSS Provider (Windows Server 2003 only)
◆ Navisphere Command Line Interface (CLI)
Navisphere Storage System Initialization Utility
The Navisphere Storage System Initialization Utility is supported for
both AX-Series and CX-Series storage systems. You must initialize the
storage system in order to register the server HBAs with the storage
system and have access to the storage system's data.
For CX-Series storage systems, use the utility to discover storage
systems, and set network parameters (IP address, subnet mask and
default gateway). An authorized service provider must install and
run the Initialization Utility.
For AX-Series storage systems, use the utility to discover storage
systems, set network parameters (IP address, subnet mask and
default gateway), and create management user accounts. For AX150
iSCSI storage systems, use the utility to set network parameters for
the storage system's iSCSI data ports.
Important The Navisphere Initialization Utility is supported only on the
CX300, CX500, CX700, and AX-Series storage systems. CX-Series and
AX100-Series systems must be running FLARE OE 02.16.xxx.5.yyy or higher.
AX150-Series systems must be running FLARE 02.20.xxx.5.yyy or higher.