A-26
EMC CLARiiON Server Support Products for Windows Installation Guide
Silent Installations and Removals
Installing Navisphere CLI
Depending on which revision of Navisphere CLI is installed, follow
the appropriate procedure below.
Important We do not recommend that you install Navisphere CLI using the
command line interface unless you are an advanced user. If you are not, we
recommend that you install the utility using the InstallShield Wizard as
described in Chapter 5, Installing and Using Navisphere CLI.
Installing revision 6.7 or earlier
If you are installing Revision 6.7 or earlier of, you must use the
InstallShield Wizard as described in
Chapter 5, Installing and Using
Navisphere CLI
.
Installing revision 6.16 or later
If you are installing Revision 6.16 or later, refer to the procedure
below.
Preparing for the installation
1. Log in to the Windows server as Administrator or someone who
has administrative privileges.
2. If CLI is already installed, you must remove it, as described on
page A-29 if removing Revision 6.16 or later or on page 5-4 if
removing for Revision 6.7 or earlier. The installation program
does not let you overwrite an existing CLI program.
3. In the server’s drive, insert the server support CD that shipped
with your storage system or your upgrade kit (for AX-Series
systems upgrading to Navisphere Manager).
4. From the CD-ROM directory, navigate to the windows > navicli
folder.
5. Select the NaviCLI.exe file.
6. Click Next in the Navisphere CLI - Welcome dialog box.
To Next Page
Loading...
