Installing the Navisphere Initialization Utility
A-5
Silent Installations and Removals
Performing a silent installation
1. On another attached Windows server (not the same server on
which you created the response file), enter one of the commands
below to install the Initialization Utility.
Setup.exe -s -f1fullpath\responsefilename -f2fullpath\logfilename
where
-s
Indicates a silent installation. A silent installation requires no
input after you enter the command.
-f1fullpath\responsefilename
Specifies the full path name of the Initialization Utility
response file you created in step 1, page A-4.
-f2fullpath\logfilename
Specifies the full path name and filename of the log file. We
recommend that you create the log file on a local directory so
you do not override a log file from another server’s
installation.
2. Verify that the installation was successful (see Verifying the silent
installation or removal on page A-32) before running the command
on all remaining attached Windows servers.
3. If the installation was successful, repeat step 1 on all remaining
attached Windows servers.
To Next Page
Loading...
