Removing Navisphere CLI
A-31
Silent Installations and Removals
-f1full path\responsefilename
Specifies the full pathname of the response file created in step
5 on page A-30.
-f2fullpath\logfilename
Specifies the full pathname and filename of the log file.
Example:
RunDll32
C:\PROGRA~1\COMMON~1\INSTAL~1\engine\6\INTEL3
~1\ctor.dll,LaunchSetup "C:\Program Files\InstallShield
Installation
Information\{249CF790-30CE-11D4-9A87-0060B0FB53A4}\
Setup.exe" -STARTEDFROMADDREMOVEPROGRAMS -s
-f1E:\aSafeDir\cliUninst.iss
-f2C:\aLocalSafeDir\cliUninst.log
where -s specifies that a silent operation will be performed, in this
case a removal, using the response file recorded in
E:\aSafeDir\cliUninst.iss. It will then log the result in
C:\aLocalSafeDir\cliUninst.log.
3. Verify that the removal was successful (refer to the next section,
Verifying the silent installation or removal) before running the
command on all the other attached Windows servers.
4. If the removal was successful, repeat steps 1 and 2 on all
remaining attached Windows servers.
To Next Page
Loading...
