DPSI RV Mini Family Operating Instructions Version 1.0
Page 19 of 54
In order to allow for optical power-on control, an ultra bright LED has
been built into the switch actuator of the DPSI RV Mini. It signals
power-on and low voltage or other errors of the battery / batteries by
blinking even over large distances.
All commercially available remote control systems (JR, Futaba,
Multiplex, Spektrum) with all available modulations (PCM, SPCM,
PCM1024, PPM, IPD), 2.4GHz as well, were tested in connection with
DPSI RV Mini systems. Therefore all systems can be utilized with no
problems.
Receivers which are supplied with 2.7 volts internally (e.g. Futaba
6014), can be used without hesitation, because the servo pulses in the
DPSI RV Mini are already recognized at 1.6 volts reliably. Servo
amplifiers in the DPSI RV Mini are supplied by their own voltage which
is totally independent from the regular servo and receiver voltage.
Therefore, voltage peaks and voltage drops do not have any influence
to the pulse quality. Due to its sophisticated safety features in
connection with elaborate testing, operating errors and outside
influences usually do not lead to damage of the DPSI RV Mini.
To Next Page
Loading...
