DPSI RV Mini Family Operating Instructions Version 1.0
Page 33 of 54
Removing the battery plugs from the DPSI RV Mini:
9.9. Setting the Voltages
The output voltage of the DPSI RV Mini can be set in 2 steps for the
receiver as well as the servos. This is done using delivered jumpers
which are plugged to the multi-pin connectors of the DPSI RV Mini
depending on the desired output voltage. Best use a tweezers or small
pliers.
Setting the voltage of the receiver and the servos to 5.9 Volt:
To Next Page
Loading...
