DPSI RV Mini Family Operating Instructions Version 1.0
Page 50 of 54
Hint:
Limits for recognizing low voltage are especially set up for operating RC models.
When utilizing the DPSI RV Mini for other purposes erroneous information could
eventually be output. If this is the case the error indication (if disturbing) can be
completely inhibited (see also "Programming the Battery Type“).
Hint:
Low voltage recognition is only pointing to batteries getting weak and do not
absolve the user from his/her care of only to fly with fully charged batteries! Due
to different characteristics of batteries from different manufacturers low voltage
recognition does not feature 100% safety.
14. Safety Directions
In general, all connecting lines should be run so that they do not
come into contact with moving or hot parts of the model (such as
servos, gears or mufflers).
The DPSI RV Mini must be protected from humidity and moisture.
The DPSI RV Mini must be located at a sufficient distance from
neighboring surfaces to enable good heat dissipation of the
cooling element.
Improper handling of the DPSI RV Mini can result in serious
damage/injury to property or persons!
Carry out a general inspection of all connections in your model
before each use! All plugs must be correctly polarized and have
clean contacts (i.e. fit tightly). Loose cables present a potential
hazard!
Under no circumstances may power sources that do not meet the
specified voltages be used.
The current-conducting contacts of the connector plugs may not
be short-circuited. If you fail to observe this warning, the short-
circuited cables may overheat and even melt.
The DPSI RV Mini may not be taken apart or technically altered
under any circumstances.
To Next Page
Loading...
