DPSI RV Mini Family Operating Instructions Version 1.0
Page 39 of 54
10. Servo-Matching
There are built-in V-cables in a DPSI RV
Mini allowing two servos to connect to one
receiver channel (Mini 5 has three V-
cables; Mini 6 has one V-cable). As a
specialty, MAGIC versions allow to
program the direction, center- and end
positions for one of both servos ("slave"
servo). This servo therefore can be
"matched" to the main servo (MSTR).
This is especially helpful if e.g. two servos actuate one rudder and
synchronized movement is not possible by mechanically adjustments
(e.g. two servos for one aileron). Often it suffices to change one
servo's direction. This is also simply possible with the MAGIC version.
Failsafe-Function:
Additionally a failsafe function has been integrated. An erroneous or
missing receiver signal stops both servos (master and slave) at their
current position (hold) until a valid receiver signal is recognized again.
This state is indicated by a flashing green LED on the upper side of the
housing ("status") which stays active until power is turned off. After the
flight the flashing LED indicates a failsafe situation.
High Precision:
Due to the intelligent software design and a highly accurate crystal
oscillator resolution is more than 3000 steps. Therefore, the system is
suitable even for modern remote controls with high servo positioning
accuracy (number of steps).
To Next Page
Loading...
