Emerson Daniel 3415

Edit/Compare configuration parameter changesFigure 7-2:
4. Click the question mark, icon to the right of a data point to display the additional
information.
5. Click Write All to write the full configuration to a meter. Depending on the View
selected, the displayed configuration may not be the full configuration. Click Write
Checked to write only the values with a selected check box next to the value and are
visible in the currently selected view. Select any values to write and clear any values
you don't want to write to the meter before clicking Write Checked.
6. Open a configuration in the editor and select Meter or select File to compare it to a
configuration saved as a file.
7. Click Compare to either read the configuration from the meter or open the Open
dialog box to select the configuration to compare to the one in the editor
Once the configurations are selected, a dialog displays, providing options to further
customize the compare operation.
Compare Configurations Options dialogFigure 7-3:
• Exclude registers that are typically different: includes items that could change
regularly such as SpecFlowPressure, SpecFlowTemperature, Gas composition,
etc. A complete list is defined in reg_list_compare_config_exclude.txt found
under the installation directory for Daniel MeterLink.
Commands
Operations manual 111