Emerson Daniel 3415

• Secondary - set to match the Content for Current Output 2
• Third - select from the following variables: Uncorrected flow rate, corrected flow
rate, Average flow velocity, Energy flow rate, Mass flow rate Pressure and
Temperature
• Fourth - select from the following variables: Uncorrected flow rate, corrected flow
rate, Average flow velocity, Energy flow rate, Mass flow rate Pressure and
Temperature
5.7.2 Configure the device identification
Configure the common variables in HART devices used to identify the particular device.
• Tag - the tag name for the HART device which may be used by host systems to
uniquely identify the meter. The tag may be up to 8 characters in length.
• Long tag - the specified long tag matches that of the meter. The tag may be 32
bytes in length.
• Date - a 3 byte value where the most significant byte is the day of the month (1-31),
the second byte is the month of the year (1-12), and the third byte is the year-1900.
• Message - a string value that can be no more than 32 characters in length.
• Descriptor - a string value that can be no more than 16 characters in length.
• Final assembly number - a numeric value that must be between 0 and 1677215.
• Polling address - the HART address for the meter. By default the meter is 0 but the
address can range from 0 to 63.
5.7.3
Configure the HART units
Configure the units that values will be read in over the HART interface.
• Volume units
• Mass units
• Energy units
• Flow rate time units
• Velocity
• Pressure
• Temperature
5.8
Configure Meter corrections
Meter profile corrections are used for Daniel 3415 and 3416 Ultrasonic Flow meters only as
shown in , and .
5.8.1
Flow profile correction
Select the profile correction; Fixed, Calculated or Default.
Configurations
62 3410 Series Gas Ultrasonic Flow meters