Emerson Micro-Motion 2400S - Page 74

66 Micro Motion
®
Model 2400S Transmitters with Analog Outputs
Using the Transmitter
With the display
Table 7-3 shows how you can control the totalizers and inventories with the display.
Table 7-2 Totalizer and inventory control methods
Function name Communicator ProLink II Display
(1)
(1) Transmitters with display only.
Start/stop all totalizers and inventories Yes Yes Yes
(2)
(2) If enabled. See Section 8.10.3.
Reset mass totalizer value only Yes Yes Yes
(2)
Reset volume (liquid or gas) totalizer only Yes Yes Yes
(2)
Simultaneously reset all totalizer values Yes Yes Yes
(2)
Simultaneously reset all inventory values No Yes
(3)
(3) If enabled in the ProLink II Preferences window.
No
Reset mass inventory value only No Yes
(3)
No
Reset volume (liquid or gas) inventory value only No Yes
(3)
No
Table 7-3 Totalizer and inventory control with the display
To accomplish this Press this sequence of buttons
Stop all totalizers and
inventories
(1)
(1) This feature may be enabled or disabled. See Section 8.10.3.
• Scroll until a totalizer value appears (the word TOTAL appears in the lower left corner of
the display). It does not matter whether the total is mass or volume.
• Select.
• Scroll until STOP appears beneath the current totalizer value.
• Select (
YES alternates with STOP).
• Select (all totalizers and inventories stop).
• Scroll to EXIT.
Start all totalizers and
inventories
(1)
• Scroll until a totalizer value appears (the word TOTAL appears in the lower left corner of
the display). It does not matter whether the total is mass or volume.
• Select.
• Scroll until
START appears beneath the current totalizer value.
• Select (
YES alternates with START).
• Select (all totalizers and inventories start).
• Scroll to
EXIT.
• Select.
Reset mass totalizer
(1)
• Scroll until the mass totalizer value appears.
• Select.
• Scroll until RESET appears beneath the current totalizer value.
• Select (
YES alternates with RESET).
• Select (mass totalizer resets).
• Scroll to
EXIT.
• Select.
Reset volume (liquid or
gas) totalizer
(1)
• Scroll until the volume totalizer value appears.
• Select.
• Scroll until
RESET appears beneath the current totalizer value.
• Select (
YES alternates with RESET).
• Select (volume totalizer resets).
• Scroll to
EXIT.
• Select.