Emerson Micro-Motion 2400S - Page 92

84 Micro Motion
®
Model 2400S Transmitters with Analog Outputs
Optional Configuration
A016 Line RTD Temperature Out-Of-Range Fault Yes Yes
Line RTD Temperature Out-of-Range
A017 Meter RTD Temperature Out-Of-Range Fault Yes Yes
Meter RTD Temperature Out-of-Range
A020 Calibration Factors Unentered Fault Yes No
Calibration Factors Unentered (FlowCal)
A021 Unrecognized/Unentered Sensor Type Fault No No
Incorrect Sensor Type (K1)
A029 Internal Communication Failure Fault No No
PIC/Daughterboard Communication Failure
A030 Hardware/Software Incompatible Fault No No
Incorrect Board Type
A031 Undefined Fault No No
Low Power
A032
(1)
Meter Verification Fault Alarm Fault No No
Meter Verification/Outputs In Fault
A032
(2)
Outputs Fixed during Meter Verification Varies
(3)
No No
Meter Verification In Progress and Outputs
Fixed
A033 Tube Not Full Fault No Yes
Tube Not Full
A034
(2)
Meter Verification Failed Info Yes No
Meter Verification Failed
A035
(2)
Meter Verification Aborted Info Yes No
Meter Verification Aborted
A100 Primary mA Output Saturated Info Yes
(4)
No
Primary mA Output Saturated
A101 Primary mA Output Fixed Info Yes
(4)
No
Primary mA Output Fixed
A102 Drive Over-Range Info Yes No
Drive Overrange
A104 Calibration-In-Progress Info Yes
(4)
No
Calibration in Progress
A105 Slug Flow Info Yes No
Slug Flow
A106 Burst Mode Enabled Info Yes
(4)
No
Burst Mode Enabled
A107 Power Reset Occurred Ignore Yes No
Power Reset Occurred
Table 8-7 Status alarms and severity levels continued
Alarm code
Communicator message
Default
severity Configurable
Affected by
fault timeoutProLink II message