2.4.3 Launching Engineering Assistant
About this task
Flow configuration for the Rosemount 3051SMV is achieved by launching the Engineering
Assistant Software from the START menu. The following steps show how to open the
Engineering Assistant Software, and connect to a device:
Procedure
1. Select the Start menu > All Programs > Engineering Assistant. Engineering
Assistant will open to screen as shown in Figure 2-4.
2. If working offline, select the Offline button located on the bottom of the screen as
shown in Figure 2-4.
Example
OR
If working online, select the Search button located on the lower right corner of the screen
as shown in Figure 2-4. Engineering Assistant will begin to search for online devices. When
the search is completed, select the device to communicate with and select Receive
Configuration button.
The HART Master Level can be set to either primary or secondary. Secondary is the default
and should be used when the transmitter is on the same segment as another HART
communication device. The COM Port and device address may also be edited as needed.
Figure 2-4: Engineering Assistant Device Connection Screen
2.4.4
Preferences
The Preferences tab, shown in Figure 2-5, allows the user to select the preferred
engineering units to display and specify flow configuration information.
Reference Manual Configuration
00809-0100-4803 October 2018
Emerson.com/Rosemount 15
To Next Page
Loading...
