• Select the preferred engineering units. If units are needed other than the default U.S.
or S.I. units, use the Custom Units setting. If Custom Units are selected, configure the
Individual Parameters using the drop-down menus.
• Unit preferences selected will be retained for future Engineering Assistant sessions.
Check the box to prevent the Preferences tab from being automatically shown in future
sessions. The Preferences are always available by select the Preferences tab.
Figure 2-5: Preferences Tab
2.4.5 Fluid selection for database liquid/gas
About this task
The Fluid Selection tab (see Figure 2-6) allows the user to select the process fluid.
Configuration Reference Manual
October 2018 00809-0100-4803
16 Rosemount 3051S Multivariable Transmitter
To Next Page
Loading...
