Figure 3-3: Cover Jam Screw
A. Cover jam screw (one per side)
Process flange orientation
Mount the process flanges with sufficient clearance for process connections. For safety
reasons, place the drain/vent valves so the process fluid is directed away from possible
human contact when the vents are used. In addition, consider the need for a testing or
calibration input.
3.4.4
Mount the transmitter
Figure 3-4 illustrates a typical Rosemount 3051SMV installation site measuring dry gas
with an orifice plate.
Installation
Reference Manual
October 2018 00809-0100-4803
76 Rosemount 3051S Multivariable Transmitter
To Next Page
Loading...
