Reference Manual
00809-0100-4840, Rev. BA
July 2008
Rosemount 3100 Series
4-16
b) Press the blue button → to enter the “ProF” menu and display the present
profile selection.
c) If the selected profile is correct, press the red button
↵ to exit to the menu.
(The menu option “ProF” re-appears. To get to the next menu, press
↓.)
d) Press the blue button → to start the editing mode. The selected profile
flashes to indicate it can now be edited.
e) Press the green button
↓ repeatedly to scroll through the list of profiles
(see above.)
f) Press the blue button
→ to confirm the new profile. (The flashing stops.)
g) If the new profile is correct, press the red button
↵ to save. The display will
change to the next menu option.
h) If the new profile is incorrect, press the blue button
→ to exit to the menu.
The “ProF” re-appears; re-start at step (b) or press
↓ for the next menu.
NOTE:
• If the saved profile is “Lin”, the next menu option is “SCALE”
(see “K-factor for the Flow Law (The 3102/3105)“ on page 4-19).
• If another contents profile is saved, the next menu is “
Cont @ max
”
(see “Maximum Contents (Volume) Entry (The 3102/3105)“ on page 4-22.)
Flow measurement
Table 4-1 lists the options that select a standard flow structure for the profile
and the conversion (scale) factors used to obtain the flow PV.
There are two other profiles:
• SPEC.P Special plotted: this option is only visible when the transmitter
is configured using a HART Master (e.g. a Rosemount 3490
Series Control Unit.)
• SPEC.C Special calculated: this option is used when a standard profile
is not available from the transmitter’s library. A power factor
and a K-factor can be edited for an unsupported flow structure,
or to allow for imperfections in a standard flow structure.
(See Power Factor for the Flow Law (The 3102/3105) and
“K-factor for the Flow Law (The 3102/3105)“ on page 4-19.)
NOTE:
This menu option is in the programming menu. See Figure C-2 on page C-3
for a map of the menu structure and how to access the menu options.
To change the flow profile:
a) If entering the menu system from the PV display, press the green button
↓
repeatedly until the “ProF” menu option is indicated (see above note.)
b) Press the blue button
→ to enter the “ProF” menu and display the present
profile selection.
c) If the selected profile is correct, press the red button
↵ to exit to the menu.
(The menu option “ProF” re-appears. To get to the next menu, press
↓.)
d) Press the blue button → to start the editing mode. The selected profile
flashes to indicate it can now be edited.
e) Press the green button
↓ repeatedly to scroll through the list of profiles
(see above profile SPEC.C, and Table 4-1 on page 4-18.)
To Next Page
Loading...
