Endress+Hauser Cerabar M - Page 154

Commissioning with the FF configuration program Cerabar M, Deltabar M, Deltapilot M
154 Endress+Hauser
12 By means of the Full height/
LEVEL_100_PERCENT_EASY parameter, enter a
height, here 4.5 m for example.
A0031066
Fig. 47: Calibration without reference pressure – dry
calibration
A See Table, step 8.
B See Table, step 9.
C See Table, step 10.
D See Table, step 11.
E See Table, step 12.
13 Set the Pressure Transducer Block to the "Auto" block
mode.
14 If necessary, configure the
Channel/CHANNEL ( ä 211),
Linearization Type/L_TYPE ( ä 212),
Transducer Scale/XD_SCALE ( ä 210) and
Output Scale/OUT_SCALE ( ä 211) parameters
by means of the Analog Input Block.
Description
A
h
p
g
=
×r
h
p
g
=
×r
r=1
g
cm
3
B
D
CE
V
[l]
h
[m]
h
[m]
p
[mbar]
1000
4.5
0
0.5
0.5
50
4.5
450