Description of device parameters Cerabar PMP21 IO-Link
46 Endress+Hauser
14.2 Diagnosis
Device Status
Navigation Diagnosis → Diagnosis → Device Status
Description Current device status
Selection • 0 = Device OK
• 1 = Maintenance required
• 2 = Out of specification
• 3 = Functional test
• 4 = Error
Detailed Device Status
Navigation Diagnosis → Diagnostic → Detailed Device Status
Description Events currently pending
Actual Diagnostics (STA)
Navigation Diagnosis → Actual Diagnostics (STA)
Description Displays the current device status.
Last Diagnostic (LST)
Navigation Diagnosis → Last Diagnostic (LST)
Description Displays the latest device status (error or warning) that was rectified during operation.
Simulation Switch Output (OU1)
Navigation Diagnosis → Simulation Switch Output (OU1)
Description The simulation affects the process data only. It does not affect the physical switch output.
If a simulation is active, a warning to this effect is displayed so that it is obvious to the user
that the device is in the simulation mode. A warning is communicated via IO-Link (C485 -
simulation active). The simulation must be ended actively via the menu. If the device is
disconnected from the power supply during the simulation and power is then resupplied,
the simulation mode is not resumed, and instead the device continues operation in the
measuring mode.
To Next Page
Loading...
