Cerabar PMP21 IO-Link Description of device parameters
Endress+Hauser 55
SSC1.1 Param. SP2
Navigation Parameter → Signal Switching Channels 1.1 → SSC1.1 Param. SP2
Description Switch point 2 of switching signal SSC1.1 for pressure
Selection No selection. The user is free to edit the values.
SSC1.1 Config. Logic
Navigation Parameter → Signal Switching Channels 1.1 → SSC1.1 Config. Logic
Description Logic for inverting the switching signal SSC1.1 for pressure
Selection • 0 = High active
• 1 = Low active
Factory setting 0
SSC1.1 Config. Mode
Navigation Parameter → Signal Switching Channels 1.1 → SSC1.1 Config. Mode
Description Module of switching signal SSC1.1 for pressure
Selection • 0 = Deactivated
• 1 = Single point
• 2 = Window
• 3 = Two-point
Factory setting 0
SSC1.1 Config. Hyst.
Navigation Parameter → Signal Switching Channels 1.1 → SSC1.1 Config. Hyst.
Description Hysteresis of switching signal SSC1.1 for pressure
Selection No selection. The user is free to edit the values.
Switching delay time, output 1 (dS1)
Navigation Parameter → Signal Switching Channels 1.1 → Switching delay time, output 1 (dS1)
To Next Page
Loading...
