Description of device parameters Cerabar PMP21 IO-Link
54 Endress+Hauser
Teach Single Value
Teach Select
Navigation Parameter → Teach → Single Value → Teach Select
Description Selection of switching signal to be taught
Selection • 0 = Default Channel = SSC1.1 Pressure
• 1 = SSC1.1 Pressure
• 2 = SSC1.2 success
• 255 = All SSC
Factory setting 1
Teach SP1
Navigation Parameter → Teach → Single Value → Teach SP1
Description System command (value 65) "Teach switch point 1"
Teach SP2
Navigation Parameter → Teach → Single Value → Teach SP2
Description System command (value 66) "Teach switch point 2"
Teach Result State
Navigation Parameter → Teach → Single Value → Teach Result State
Description Result of the activated system command
Switching Signal Channels
Switching Signal Channel 1.1
SSC1.1 Param. SP1
Navigation Parameter → Signal Switching Channels 1.1 → SSC1.1 Param. SP1
Description Switch point 1 of switching signal SSC1.1 for pressure
Selection No selection. The user is free to edit the values.
To Next Page
Loading...
