Cerabar M, Deltabar M, Deltapilot M / 4...20 mA HART Wiring
Endress+Hauser 37
4.5 Post-connection check
Perform the following checks after completing electrical installation of the device:
• Does the supply voltage match the specifications on the nameplate?
• Is the device connected as per Section 4.1?
• Are all screws firmly tightened?
• Are the housing covers screwed down tight?
As soon as voltage is applied to the device, the green LED on the electronic insert lights up for a few
seconds or the connected local display lights up.
To Next Page
Loading...
