EasyManuals Logo

Endress+Hauser Deltabar M PMD55 User Manual

Endress+Hauser Deltabar M PMD55
134 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Identification Cerabar M, Deltabar M, Deltapilot M / 4...20 mA HART
6 Endress+Hauser
2 Identification
2.1 Device designation
2.1.1 Device identification via the nameplate
!
Note!
The MWP (maximum working pressure) is specified on the nameplate. This value refers to a
reference temperature of 20°C (68°F) or 100°F (38 °C) for ANSI flanges.
The pressure values permitted at higher temperatures can be found in the following standards:
EN 1092-1: 2001 Tab. 18
1)
ASME B 16.5a – 1998 Tab. 2-2.2 F316
ASME B 16.5a – 1998 Tab. 2.3.8 N10276
JIS B 2220
The test pressure corresponds to the over pressure limit (OPL) of the device = MWP x 1.5
2)
.
The Pressure Equipment Directive (EC Directive 97/23/EC) uses the abbreviation "PS". The
abbreviation "PS" corresponds to the MWP (maximum working pressure) of the measuring
device.
Aluminum housing
P01-xMx5xxxx-18-xx-xx-xx-000
Fig. 1: Nameplate
1 Device name
2 Ordercode (complete)
3 Orderident (for re-orders)
4 Serial number (for identification)
5 MWP (maximum working pressure)
6 Electronic version (output signal)
7 Min./max. span
8 Nominal measuring range
9 Supply voltage
10 Length data
11 ID number of notified body with regard to ATEX (optional)
12 ID number of notified body with regard to Pressure Equipment Directive (optional)
13 Approvals
14 Degree of protection
15 Wetted materials
16 Deltabar M: Cable entry; Deltapilot M: Wetted materials
17 Approval-specific information
18 Software Revision
19 Device Revision
Devices suitable for oxygen applications are fitted with an additional nameplate.
1) With regard to their stability-temperature property, the materials 1.4435 and 1.4404 are grouped together under 13EO
in EN 1092-1 Tab. 18. The chemical composition of the two materials can be identical.
2) The equation does not apply for PMP51 and PMP55 with a 40 bar (600 psi) or a 100 bar (1500 psi) measuring cell.
2
1
3
4
5
8
6
9
10
7
11
12
13
14
15
16
17
17
18
19
Ex works SW:
Dev.Rev.:
Mat.:
250005756-–
250002755-–
Orderident.:
Ser.-No.:
Vmax.
Span
P
MWP
Ordecode:
Made in Germany, D-79689 Maulburg

Table of Contents

Other manuals for Endress+Hauser Deltabar M PMD55

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Endress+Hauser Deltabar M PMD55 and is the answer not in the manual?

Endress+Hauser Deltabar M PMD55 Specifications

General IconGeneral
BrandEndress+Hauser
ModelDeltabar M PMD55
CategoryTransmitter
LanguageEnglish

Related product manuals