Endress+Hauser Deltabar S PMD75 - Page 189

Cerabar S/Deltabar S/Deltapilot S FOUNDATION Fieldbus Parameter description (Local operation and FieldCare)
Endress+Hauser 189
P01-xxxxxxxx-19-xx-xx-en-099
Fig. 53: LINEARIZATION function group for FieldCare
EDITOR TABLE
LINE-NUMB.
LIN. EDIT MODE
Editor Table
Measuring Table
Level measuring
mode only
EDITOR TABLE
LINE-NUMB.
X-VAL
Y-VAL
ACTIVLIN.TAB. X
ACTIVLIN.TAB. Y
TANK DESCRIPTION
TANK CONTENT MIN
TANK CONTENT MAX
TABLE SELECTION
QUICK SETUP
DISPLAYSETTINGS
POSITION ADJUSTMENT
OPERATING MENU
Measured v
alue
LINEARIZATION
Table 19: MANUFACTURER VIEW → OPERATING MENU → SETTINGS → LINEARIZATION – FieldCare
Parameter name Description
Prerequisite:
• MEASURING MODE = Level (→ ä 134).
• LEVEL MODE = Pressure linearized or height linearized (→ ä 156).
Note:
– See also → ä 105 ff, Section 9 "Level measurement (via local operation and FieldCare)".
TANK CONTENT MIN
Entry
Enter the minimum tank contents to be expected.
The input limits for the calibration (editing limits) are derived from the value entered. The
closer the value entered corresponds to the minimum tank content to be expected, the
more accurate the measurement result.
Factory setting:
0.0
TANK CONTENT MAX
Entry
Enter the maximum tank contents to be expected.
The input limits for the subsequent calibration (editing limits) are derived from the value
entered. The closer the value entered corresponds to the maximum tank content to be
expected, the more accurate the measurement result.
Factory setting:
100.0
TABLE SELECTION
Selection
Select table.
The device works with a measuring and an editor table. The measuring table is used to
calculate the measured value. To make sure measuring also runs properly when entering
a new table, there is another table, the editor table, for entering new values.
Options:
•View meas. table
•Editor table
Factory setting:
View meas. table