Endress+Hauser Gammapilot M FMG60 - Page 28

Operation Gammapilot M FMG60 PROFIBUS PA
28 Endress+Hauser
Operating key(s) Meaning
and
or
Navigate to the left within a function group
Navigate to the right within a function group, confirmation
and
or
and
Contrast settings of the LCD
and and Hardware locking/unlocking
After locking the hardware, operation via the display and communication is not possible! The
hardware can only be unlocked via the display. An access code must be entered to do so.
Configuring the device address
The address "126" configured at the factory can be used to check the function of the device and
connect it to an operating PROFIBUS-PA system. This address must be changed subsequently
to add additional devices.
The following options are available for setting the address:
• The address can be set via the display and operating module VU331 (in the FHX40).
To do so, enter the desired address in the "Device address" (*60) function in the "Profibus
Param" function group.
• The address can be set via FieldCare.
To do so, enter the desired address in the "Device address" function in the "Profibus Param"
function group.
5.1.2 The operating menu
Function codes
The functions of the Gammapilot M are arranged in an operating menu. To ensure easy
orientation within this menu, a unique position code is indicated on the display for each
function. This code consists of one alphabetic and two numeric characters.
1 2
3
A0019876-EN
1 Measurement mode
2 Function group
3 Function