To Next PageTo Next Page
What happens when Endress+Hauser Gammapilot M FMG60 issues an alarm error?
When an alarm error occurs in Endress+Hauser Measuring Instruments, the output signal assumes a value set using the "output on alarm" function. This value can be MAX (110%, 22mA), MIN (-10%, 3.8mA), Hold (last value is on hold), or a user-specific value. Additionally, an error message is displayed.
How to fix 'Background not calibrated' error on Endress+Hauser Measuring Instruments?
To resolve the 'Background not calibrated' error on your Endress+Hauser Measuring Instruments, perform a background calibration using the "calibration" (*1) function group.
What to do if Endress+Hauser Gammapilot M FMG60 Measuring Instruments display 'Density not calibrated'?
To resolve a 'Density not calibrated' error on your Endress+Hauser Measuring Instruments: * Verify that at least one calibration point has been entered and activated in the "calibration" (*1) function group; if not, enter and activate calibration point(s). * Check if the "reference pulse rate" (*1F) is larger than 232; if it is, re-perform density calibration in the "calibration" (*1) function group.
What to do if background not calibrated on Endress+Hauser Measuring Instruments?
If your Endress+Hauser Measuring Instruments display 'background not calibrated', perform background calibration using the calibration function group.
How to stop calibration integration running on Endress+Hauser Gammapilot M FMG60 Measuring Instruments?
If your Endress+Hauser Measuring Instruments are stuck on 'calibration integration running', wait until a stable pulse rate has been reached. Then, terminate the integration by pressing "E" in the "average pulse rate" function.
What to do if empty/free not calibrated on Endress+Hauser Gammapilot M FMG60 Measuring Instruments?
If Endress+Hauser Measuring Instruments are showing a 'empty/free not calibrated' message, perform an empty/free calibration using the calibration function group.
What to do if full/covered not calibrated on Endress+Hauser Measuring Instruments?
If Endress+Hauser Measuring Instruments are showing a 'full/covered not calibrated' message, perform a full/covered calibration using the calibration function group.
General| Measurement Principle | Gamma radiation absorption |
|---|---|
| Housing Material | Aluminum or stainless steel |
| Protection Class | IP66/67 |
| Radiation Source | Cesium-137 (Cs-137) or Cobalt-60 (Co-60) |
| Accuracy | ±1% of measuring range |
| Output Signal | 4 to 20 mA HART |
| Power Supply | 10.5 to 45 V DC |
| Ambient Temperature | -20 to +60 °C |
| Communication | HART |
| Certifications | ATEX, IECEx |
| Application | Density, level, or concentration measurement in liquids, solids, suspensions or slurries |
| Process Temperature | -40 to +80 °C |
