Operating menu Micropilot FMR10
60 Endress+Hauser
"Administration" submenu
Navigation Setup → Advanced setup → Administration
Define access code
Navigation Setup → Advanced setup → Administration → Define access code
Description Define release code for changing device operation mode. If the factory setting is not
changed or 0000 is defined as the access code, the device works in maintenance mode
without write-protection and the configuration data of the device can then always be
modified. Once the access code has been defined, write-protected devices can only be
changed to maintenance mode if the access code is entered in the Enter access code
parameter. The new access code is only valid after it has been confirmed in the Confirm
access code parameter. Please contact your Endress+Hauser Sales Center if you lose your
access code.
User entry 0 to 9 999
Factory setting 0
Confirm access code
Navigation Setup → Advanced setup → Administration → Confirm access code
Description Re-enter the entered access code to confirm.
User entry 0 to 9 999
Factory setting 0
Device reset
Navigation Setup → Advanced setup → Administration → Device reset
Description Reset the device configuration - either entirely or in part - to a defined state.
Selection • Cancel
• To factory defaults
Factory setting Cancel
To Next Page
Loading...
