Endress+Hauser Micropilot FMR10 - Advanced Setup Submenu

Operating menu Micropilot FMR10
52 Endress+Hauser
13.2.1 "Advanced setup" submenu
Navigation  Setup → Advanced setup
Access status tooling
Navigation  Setup → Advanced setup → Access status tooling
Description Shows the access authorization to the parameters via the operating tool.
Enter access code
Navigation  Setup → Advanced setup → Enter access code
Description The customer-specific access code, which has been defined in the Define access code
parameter, must be entered to change from the Operator to the Maintenance mode. The
device remains in the Operator mode if an incorrect access code is entered. If you lose the
access code, please contact your Endress+Hauser sales center.
User entry 0 to 9 999
Factory setting 0
Evaluation sensitivity 
Navigation  Setup → Advanced setup → Evaluation sensitivity
Description Selection of the evaluation sensitivity Options to select from: - Low Interferers but also
small level signals are not recognized. The weighting curve is located high. - Medium The
weighting curve is in a medium region. - High Small level signals but also interferers can
be reliably detected. The weighting curve is located low.
Selection • Low
• Medium
• High
Factory setting Medium
Changing velocity 
Navigation  Setup → Advanced setup → Changing velocity
Description Selection of the expected draining or filling speed of the measured level.