Endress+Hauser Proline Promag 50 - Page 113

PROline Promag 50 10 Technical data
Endress+Hauser 113
Pressure tightness
(liner)
Limiting flow see Page 20
Pressure loss • No pressure loss if the sensor is installed in a pipe of the same nominal diameter
(Promag H: only DN 8 and larger).
• Pressure losses for configurations incorporating adapters according to
(E) DIN EN 545 → Page 20
Promag W
Nominal diameter
Measuring
tube lining
Resistance of measuring tube lining to partial vacuum
Limit values for abs. pressure [mbar] at various fluid temperatures
[mm] [inch] 25 °C 70 °C 80° C 100 °C 130 °C 150 °C 180 °C
25…2000 1…78" Polyurethane 0 0
−−−−−
65…2000 3…78" Hard rubber 0 0 0
−−−−
Promag P
Nominal diameter
Measuring
tube lining
Resistance of measuring tube lining to partial vacuum
Limit values for abs. pressure [mbar] at various fluid temperatures
[mm] [inch] 25 °C 80 °C 100 °C 130 °C 150 °C 180 °C
15 1/2" PTFE 0 0 0 100 – –
25 1" PTFE / PFA 0 / 0 0 / 0 0 / 0 100 / 0 – / 0 – / 0
32
−
PTFE / PFA 0 / 0 0 / 0 0 / 0 100 / 0 – / 0 – / 0
40 1 1/2" PTFE / PFA 0 / 0 0 / 0 0 / 0 100 / 0 – / 0 – / 0
50 2" PTFE / PFA 0 / 0 0 / 0 0 / 0 100 / 0 – / 0 – / 0
65
−
PTFE / PFA 0 / 0 * 40 / 0 130 / 0 – / 0 – / 0
80 3" PTFE / PFA 0 / 0 * 40 / 0 130 / 0 – / 0 – / 0
100 4" PTFE / PFA 0 / 0 * 135 / 0 170 / 0 – / 0 – / 0
125
−
PTFE / PFA 135 / 0 * 240 / 0 385 / 0 – / 0 – / 0
150 6" PTFE / PFA 135 / 0 * 240 / 0 385 / 0 – / 0 – / 0
200 8" PTFE / PFA 200 / 0 * 290 / 0 410 / 0 – / 0 – / 0
250 10" PTFE 330 * 400 530 – –
300 12" PTFE 400 * 500 630 – –
350 14" PTFE 470 * 600 730 – –
400 16" PTFE 540 * 670 800 – –
450 18" PTFE
Partial vacuum is impermissible500 20" PTFE
600 24" PTFE
* No value can be quoted.
Promag H
Nominal diameter
Measuring
tube lining
Resistance of measuring tube lining to partial vacuum
Limit values for abs. pressure [mbar] at various fluid temperatures
[mm] [inch] 25 °C 80 °C 100 °C 130 °C 150 °C 180 °C
2…1001/12…4"PFA 000000