Endress+Hauser Proline Promag 50 - Accessories

PROline Promag 50 8 Accessories
Endress+Hauser 85
8 Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are avail-
able for the transmitter and the sensor. The E+H service organisation can provide
detailed information on the order codes of your choice.
Accessory Description Order code
Transmitter
Promag 50
Transmitter for replacement or for stock. Use
the order code to define the following specifi-
cations:
– Approvals
– Degree of protection / version
– Cable type for the remote version
– Cable entries
– Display / power supply / operation
– Software
– Outputs / inputs
50XXX
− XXXXX * * * * * * * *
Mounting kit for trans-
mitter Promag 50/53
Mounting kit for wall-mounted housing
(remote version). Suitable for:
– Wall mounting
– Post mounting
– Installation in control panel
Mounting set for aluminium housings.
Suitable for pipe mounting (3/4"...32")
DK5WM
− *
Cable for
remote version
Coil and signal cables, various lengths.
Reinforced cable on request.
DK5CA
− * *
Ground cable for
Promag W, P
A set consists of two ground cables. DK5GC
− * * *
Ground disk for
Promag W, P
Ground disk for potential equalisation DK5GD
− * * *
Mounting kit for
Promag H
Mounting kit for Promag H, comprising:
– 2 process connections (see Page 137 ff.)
– Threaded fasteners
– Seals
DKH * *
− * * *
Adapter connection for
Promag A, H
Adapter connections for installing
Promag 50 H instead of Promag 30/33 A or
Promag 30/33 H DN 25.
DK5HA
− * * * * *
Ground rings for
Promag H
If the process connections are made of PVC
or PVDF, ground rings are necessary to
ensure that potential is matched.
Set of ground rings, comprising:
– 2 ground rings
DK5HR
− * * *
Set of seals for
Promag H
For regular replacement of the seals of the
Promag H sensor.
DK5HS
− * * *
Wall-mounting kit for
Promag H
Wall-mounting kit for the Promag H sensor DK5HM
− * *
Welding jig for
Promag H
Weld nipple as process connection:
welding jig for installation in pipe.
DK5HW
− * * *