Endress+Hauser Proline Promag 50

To Next Page

To Previous Page

PROline Promag 50 5 Operation

Endress+Hauser 75

0 not assigned –

1 not assigned –

2 not assigned –

3 not assigned –

4 not assigned –

5 not assigned –

6 not assigned –

7 not assigned –

0 not assigned –

1 not assigned –

2 not assigned –

3 not assigned –

4 not assigned –

5 not assigned –

6 not assigned –

7 401 Measuring tube partially filled or empty

0 not assigned –

1 not assigned –

2 461 EPD calibration not possible because the fluid's conductivity is

either too low or too high.

3 not assigned –

4 463 The EPD calibration values for empty pipe and full pipe are

identical, therefore incorrect.

5 not assigned –

6 not assigned –

7 not assigned –

0 not assigned –

1 not assigned –

2 not assigned –

3 not assigned –

4 not assigned –

5 not assigned –

6 not assigned –

7 501 New amplifier software version is loaded.

Currently no other commands are possible.

Byte Bit Error No. Short error description ( → Page 88 ff. )

Endress+Hauser Proline Promag 50 - Page 75