Endress+Hauser Proline Promag W 500 - Supported Operating Tools

Proline Promag W 500
Endress+Hauser 103
accessed any time from the control station. The measured values are processed separately via the
inputs and outputs through the automation system.
21 3
5 5 5
4
6
7
8
A0033618
1 Automation system, e.g. Simatic S7 (Siemens)
2 Ethernet switch
3 Edge Gateway
4 Cloud
5 Measuring device
6 Ethernet network
7 Measured values via inputs and outputs
8 Optional WLAN interface
The optional WLAN interface is available on the following device version:
Order code for "Display; operation", option G "4-line, illuminated, graphic display; touch control +
WLAN"
Special Documentation for the OPC-UA-Server application package →  114.
Supported operating tools
Different operating tools can be used for local or remote access to the measuring device. Depending
on the operating tool used, access is possible with different operating units and via a variety of
interfaces.
Supported operating
tools
Operating unit Interface Additional information
Web browser Notebook, PC or tablet
with Web browser
• CDI-RJ45 service
interface
• WLAN interface
• Ethernet-based
fieldbus (EtherNet/IP,
PROFINET)
Special Documentation for
device
DeviceCare SFE100 Notebook, PC or tablet
with Microsoft Windows
system
• CDI-RJ45 service
interface
• WLAN interface
• Fieldbus protocol
→  112