Endress+Hauser Proline Promag W 500 - Vibrations; Mechanical Construction; Dimensions in si Units

Proline Promag W 500
58 Endress+Hauser
Never install the sensor on the pump suction side in order to avoid the risk of low pressure, and thus
damage to the liner.
Furthermore, install pulse dampers if reciprocating, diaphragm or peristaltic pumps are used.
• Information on the liner's resistance to partial vacuum →  56
• Information on the shock resistance of the measuring system →  53
• Information on the vibration resistance of the measuring system →  53
Vibrations
L
A0029004
 41 Measures to avoid device vibrations (L > 10 m (33 ft))
In the event of very strong vibrations, the pipe and sensor must be supported and fixed.
It is also advisable to mount the sensor and transmitter separately.
• Information on the shock resistance of the measuring system →  53
• Information on the vibration resistance of the measuring system →  53
Mechanical construction
Dimensions in SI units Housing of Proline 500 transmitter
Hazardous area: Zone 2; Class I, Division 2 or Zone 1; Class I, Division 1
T
G
A
B
C
Q
Q
F
A0033788
Order code for "Transmitter housing", option A "Aluminum, coated" and order code for "Integrated ISEM
electronics", option B "Transmitter"
A
[mm]
B
[mm]
C
[mm]
F
[mm]
G
[mm]
Q
[mm]
T
[mm]
188 85 103 318 217 130 239