Proline Promag W 500
6 Endress+Hauser
Measuring system
The measuring system consists of a transmitter and a sensor. The transmitter and sensor are
mounted in physically separate locations. They are interconnected by connecting cables.
Transmitter
For use in applications required to meet special requirements due to ambient or operating
conditions.
1 Transmitter with integrated ISEM
2 Coil current cable
3 Signal cable
4 Sensor connection housing
Application examples for sensors without electronics:
• Strong vibrations at the sensor.
• Sensor in underground installations.
• Permanent immersion of sensor in water, IP68 ingress protection.
• Electronics and ISEM (intelligent sensor electronics module) in the transmitter housing.
• Signal transmission: analog
Order code for "Integrated ISEM electronics", option B: transmitter
Connecting cable
Connecting cables can be ordered in various lengths → 110 )
• Length: max. 200 m (656 ft), depending on medium conductivity
• Two connecting cables:
– One cable for coil current with a common shield (1 pair)
– One cable for signal transmission with a common shield and individual shielded cores (2 pairs)
Ex Zone
Use in: Ex Zone 1 and 2; Class 1, Division 2 and Class 1, Division 1
Device versions and materials
• Transmitter housing
Aluminum, coated: aluminum, AlSi10Mg, coated
• Window material: glass
Configuration
• External operation via 4-line, backlit, graphic local display with touch control and guided menus
("Make-it-run" wizards) for application-specific commissioning.
• Via service interface or WLAN connection:
– Operating tools (e.g. FieldCare, DeviceCare, SmartBlue app)
– Web server (access via Web browser, e.g. Microsoft Internet Explorer, Microsoft Edge)
To Next Page
Loading...
