Endress+Hauser Proline Promag W 500

To Next Page

To Previous Page

Proline Promag W 500

Endress+Hauser 23

PROFIBUS PA

Manufacturer ID 0x11

Ident number 0x156C

Profile version 3.02

Device description files (GSD,

DTM, DD)

Information and files under:

• www.endress.com

• www.profibus.org

Supported functions • Identification & Maintenance

Simplest device identification on the part of the control system and

nameplate

• PROFIBUS upload/download

Reading and writing parameters is up to ten times faster with PROFIBUS

upload/download

• Condensed status

Simplest and self-explanatory diagnostic information by categorizing

diagnostic messages that occur

Configuration of the device

address

• DIP switches on the I/O electronics module

• Local display

• Via operating tools (e.g. FieldCare)

Compatibility with

earlier model

If the device is replaced, the measuring device Promag 500 supports the

compatibility of the cyclic data with previous models. It is not necessary to

adjust the engineering parameters of the PROFIBUS network with the Promag

500 GSD file.

Earlier models:

• Promag 50 PROFIBUS PA

– ID No.: 1525 (hex)

– Extended GSD file: EH3x1525.gsd

– Standard GSD file: EH3_1525.gsd

• Promag 53 PROFIBUS PA

– ID No.: 1527 (hex)

– Extended GSD file: EH3x1527.gsd

– Standard GSD file: EH3_1527.gsd



Description of the function scope of compatibility:

Operating Instructions →  113.

System integration Information regarding system integration: Operating Instructions →  113.

• Cyclic data transmission

• Block model

• Description of the modules

PROFIBUS DP