Endress+Hauser Proline Promag W 800 - 5 Storage, Transport and Disposal of Packaging; Storage Conditions; Transporting the Product

Storage, transport and disposal of packaging Proline Promag W 800
12 Endress+Hauser
5 Storage, transport and disposal of packaging
5.1 Storage conditions
Note the following when storing the device:
• Store in the original packaging to protect against impact.
• Do not remove protective covers or protection caps mounted on process connections.
They prevent mechanical damage to the sealing surfaces and fouling in the measuring pipe.
• Protect from sunlight to avoid impermissibly high surface temperatures.
• Choose a storage location where moisture does not collect in the measuring device. This will
help prevent fungus and bacteria infestation which can damage the liner.
• Store in a dry, dust-free atmosphere.
• Do not store outdoors.
• Storage temperature:
– Transmitter: –20 to +60 °C (–4 to +140 °F)
–Sensor:
– Flange material carbon steel: –10 to +60 °C (14 to +140 °F)
– Flange material stainless steel: –40 to +60 °C (–40 to +140 °F)
• Also be mindful of the following when storing the batteries:
– Avoid any short-circuiting of the battery poles.
– The storage temperature should preferably be 21 °C (70 °F).
– Store in a dry, dust-free atmosphere that is not subject to large fluctuations in temperature.
– Protect from sunlight.
– Do not store near heaters.
5.2 Transporting the product
#
Warning!
Risk of injury if the measuring device slips.
The center of gravity of the measuring device is higher than the points around which the
webbing slings are slung.
• Secure the measuring device so that it does not turn around its axis or slip.
A0015606
Fig. 3: Risk of injury if the measuring device slips when transporting sensors