Endress+Hauser Proline Promag W 800 - Structure and Function of the Operating Menu

Proline Promag W 800 Operating options
Endress+Hauser 47
8.2 Structure and function of the operating menu
8.2.1 Structure of the operating menu
• The measuring device has a main menu with different parameter groups.
These parameter groups correspond to different applications or areas of the measuring
device.
• The parameter groups contain the various parameters that belong to the individual
applications or areas of the measuring device.
• The desired setting or option for the measuring device configuration is made in the individual
parameters.
• Some parameters cannot be modified since they are only used to display values or
information, or can only be modified by users with a higher access authorization level → 
51.
8.2.2 Operating concept
The parameters in the measuring device have different access levels. The parameters can be
modified by all users or just by certain user groups depending on the associated access level.
Some parameters can only be accessed via the Config 5800 operating tool.
• The parameters can be accessed via:
– The local operation of the measuring device →  48
– The Config 5800 operating tool →  51
• The majority of the parameters can be configured without any restrictions (up to Level 2).
Special service-specific and device-specific parameters (Level 3 and above) can only be
modified by Endress+Hauser Service staff.
• Custody transfer (optional):
After putting the device into circulation or after sealing the device, operation via the onsite
display, via the Config 5800 software operating tool or via GSM/GPRS is only possible to a
limited extent.
Main menu with parameter
groups
Parameters Configuration
1 - Sensor  ND  ND: mm 00050

KA  KA: mm +01.000
 Sens.Type  Sens.type = 000
…  …
2 - Scales  …  …
3 - Measure
4 - Alarms
…