Basic safety instructions Proline Promag W 800
6 Endress+Hauser
Incorrect use
The manufacturer is not liable for damage resulting from improper or non-designated use.
An improper or non-designated use can affect the safety.
Clarification of borderline cases:
• With regard to special fluids and media used for cleaning, Endress+Hauser will be happy to
assist in clarifying the corrosion-resistant properties of wetted materials but gives no
guarantee or warranty as to the suitability of the materials.
Residual risks
#
Warning!
Due to the power throughput in the electronic components, the outer housing surfaces can heat
up by a maximum of 20 K. When hot fluid passes through the measuring tube, the surface
temperature of the housing increases. In the case of the sensor, in particular, users should
expect temperatures that can be close to the fluid temperature.
Hot fluids can present a burn hazard!
• For elevated fluid temperatures, ensure adequate protection against contact to prevent burns.
2.3 Occupational safety
When working on or with the device:
• Always wear the necessary personal protective equipment as defined in national regulations.
When performing welding work on the pipe:
• Do not ground the welding equipment via the measuring device.
When working with batteries:
• The device is powered by lithium-thionyl chloride high-power batteries. This has implications
for occupational safety and device storage.
#
Warning!
Lithium-thionyl chloride high-power batteries are categorized as Class 9:
"Miscellaneous Hazardous Materials". Comply strictly with the hazardous material regulations
described in the safety data sheet.
You can request the safety data sheet from your Endress+Hauser Sales Center.
To Next Page
Loading...
