Commissioning Proline Promag W 800
52 Endress+Hauser
9 Commissioning
9.1 Commissioning with the GSM/GPRS modem
Detailed information on commissioning with the GSM/GPRS modem:
Operating Instructions for the device on the enclosed CD-ROM
9.2 Commissioning without the GSM/GPRS modem
Prerequisites for commissioning the measuring device:
• The measuring device has been installed.
All the criteria of the post-installation check are met → 27.
• Wiring is completed.
Batteries are inserted, external power supply is connected (optional).
All the criteria of the post-connection check are met → 45.
9.2.1 Commissioning the measuring device via local operation
1. Switch on the measuring device:
– Via the DIP switch if power is supplied by batteries → 41 (→ 24).
Then fit the housing cover back on.
– Via the external power supply switch if power is supplied externally (optional).
2. Configuration of the measuring device via the onsite display → 48.
Detailed information on parameter descriptions:
Operating Instructions for the device on the enclosed CD-ROM
9.2.2 Commissioning the measuring device via the Config 5800 operating tool
Detailed information on commissioning using the Config 5800 operating tool:
Operating Instructions for the device on the enclosed CD-ROM
9.3 Inserting the SIM card
A SIM card must be inserted in the measuring device before it can establish wireless
communication.
Detailed information on inserting the SIM card:
Operating Instructions for the device on the enclosed CD-ROM
To Next Page
Loading...
