Endress+Hauser Proline Promag W 800 - Page 41

Proline Promag W 800 Electrical connection
Endress+Hauser 41
A0017025
Fig. 24: Connecting the batteries, switching on the battery power supply
1 Cable inlet in the battery cover
2 Receptacles for terminals B1 and terminals B2 and B3
3 DIP switch (ON/OFF) for switching the batteries on and off:
- Switch 1: terminals B3
- Switch 2: terminals B1 and B2
4 DIP switch (ON/OFF) to disable the controls of the local display
6. Secure the battery cover.
– Route the battery cables in the direction of the cable inlet in the battery cover →  24.
– Fit the battery cover in place. In doing so, position the guides into the slots in the battery
cover.
– Tighten the securing screw with a Phillips head screwdriver.
– Fold down the protective cover for the external power supply.
7. Secure the housing cover.
– Fix the housing cover on the housing.
– Tighten the four screws with a Phillips head screwdriver.
1
B2
B1
B3
B1 B2 B3
ON
12
B1/B2
ON
B3
ON
12
17
16 15 14
10
987 65
13
12 11
4 321
LOCK
CPU
GSM
2
B1 B2 B3
3
ON
12
B1/B2
ON
B3
ON – OFF
B3
B1/B2
4
ON
12
LOCK
ON – OFF